EasyManuals Logo

OmniSwitch os6900 User Manual

Default Icon
942 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #659 background imageLoading...
Page #659 background image
Configuring QoS Creating Policies
OmniSwitch AOS Release 7 Network Configuration Guide June 2013 page 25-51
The following example creates a policy rule (rule1) that is automatically assigned to the default policy
list.
-> policy condition cond1 source mac 00:11:22:33:44:55 source vlan 100
-> policy action act1 disposition drop
-> policy rule rule1 condition cond1 action act1
-> qos apply
In this example, the no default-list parameter is not used with the policy rule command, so the rule is
automatically assigned to the default policy list. The default list always exists and is not configurable. As a
result, the policy list command is not required to assign the rule to the default list.
By default, a policy list is enabled at the time the list is created. To disable or enable a policy list, use the
following commands:
-> policy list unp1_rules disable
-> policy list unp1_rules enable
To remove an individual rule from a UNP policy list, use the following command:
-> policy list unp1_rules no rules r2
To remove an entire UNP policy list from the switch configuration, use the following command:
-> no policy list unp1_rules
Use the show policy list command to display the QoS policy rule configuration for the switch.
Guidelines for Configuring Policy Lists
Consider the following guidelines when configuring QoS policy rules and lists:
Create policy rules first before attempting to create a list. The policy list rules command requires that
the specified policy rules must already exist in the switch configuration. See “Creating Policies” on
page 25-43.
A rule can belong to the default list and a Universal Network Profile (UNP) list at the same time. In
addition, a rule can also belong to multiple UNP lists. Each time a rule is assigned to a policy list,
however, an instance of that rule is created. Each instance is allocated system resources.
By default, QoS assigns rules to the default policy list. To exclude a rule from this list, use the no
default-list option of the policy rule command when the rule is created. See “Using the Default Policy
List” on page 25-52 for more information.
If the rule is going to belong to a QoS policy list for a UNP, use the no default-list option when creat-
ing the rule. Doing so will give the rule precedence over default list rules when the policy list is applied
to UNP device traffic.
Only one policy list per UNP is allowed, but a single policy list can be associated with multiple
profiles. See Chapter 27, “Configuring Universal Network Profiles,” for more information.
Up to 32 policy lists (including the default list) are supported per switch.
If a rule is a member of multiple policy lists but one or more of these lists are disabled, the rule is still
active for those lists that are enabled.
If the QoS status of an individual rule is disabled, then the rule is disabled for all policy lists, even if a
list to which the policy belongs is enabled.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the OmniSwitch os6900 and is the answer not in the manual?

OmniSwitch os6900 Specifications

General IconGeneral
BrandOmniSwitch
Modelos6900
CategorySwitch
LanguageEnglish