EasyManuals Logo

OmniSwitch os6900 User Manual

Default Icon
942 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #828 background imageLoading...
Page #828 background image
sFlow Overview Diagnosing Switch Problems
page 32-10 OmniSwitch AOS Release 7 Network Configuration Guide June 2013
For more information about this command, see “sFlow” on page 32-29 or the “sFlow Commands” chapter
in the OmniSwitch CLI Reference Guide.
Follow the steps below to create a sFlow poller session.
1 To create a sFlow poller session, use the sflow poller command by entering sflow
poller, followed by the instance ID, port list, receiver, and the interval. For example:
-> sflow poller 1 2/6-10 receiver 1 interval 30
Note. Optional. To verify the sFlow poller configuration, enter show sflow poller, followed by the sFlow
poller instance ID. The display is similar to the one shown below:
-> show sflow poller
Instance Interface Receiver Interval
-------------------------------------------
1 2/ 6 1 30
1 2/ 7 1 30
1 2/ 8 1 30
1 2/ 9 1 30
1 2/10 1 30
For more information about this command, see “sFlow” on page 32-29 or the “sFlow Commands” chapter
in the OmniSwitch CLI Reference Guide.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the OmniSwitch os6900 and is the answer not in the manual?

OmniSwitch os6900 Specifications

General IconGeneral
BrandOmniSwitch
Modelos6900
CategorySwitch
LanguageEnglish