Index
Index-2 OmniSwitch AOS 7 Network Configuration Guide June 2013
bridge path cost mode command 6-31
bridge priority command 6-28
Bridge Protocol Data Units
contents 6-8
bridge slot/port command 6-30
bridge slot/port connection command 6-41
bridge slot/port priority command 6-36
built-in port groups
used with Policy Based Routing 25-79
C
clear arp filter command 15-15
clear arp-cache command 15-13
condition groups
for ACLs 25-53
MAC groups 25-57
network groups 25-54
port groups 25-58
sample configuration 25-53
service groups 25-56
verify information about 25-59
conditions
combined with actions 25-32, 25-33
configuring 25-45
how to create 25-45
see also condition groups
valid combinations 25-31
Configuring 802.1AB
application examples 13-3
D
debug messages 34-8
debug qos command 25-39
default route
IP 15-12
defaults
10/100/1000 ports 1-4
802.1AB 13-2
authentication servers 29-3
DHCP Relay 21-3
dynamic link aggregation 8-3, 9-4, 10-4, 14-4
Ethernet OAM 35-2, 36-2
Ethernet ports 1-2, 1-4
high availability VLANs 5-2
IP 15-4
IPMS 24-3, 24-5
IPv6 17-4
Learned Port Security 31-2
Multiple Spanning Tree 6-5
OSPF 18-2, 20-2
policy servers 26-2
Port Mapping 30-2
port mirroring 32-3
port monitoring 32-5, 32-7
QoS 25-34
RIP 19-2
RMON 32-12
RRSTP 6-6
Server Load Balancing 23-3
source learning 3-2
Spanning Tree Bridge 6-4, 11-3
Spanning Tree Port 6-4
static link aggregation 7-2
switch health 32-14
switch logging 34-3
UDLD 2-2
VLANs 4-2
VRRP 22-3
Denial of Service
see DoS
DHCP 21-6
DHCP Relay 21-1, 21-10
application examples 21-4, 21-7, 21-8
AVLAN forwarding option 21-11
defaults 21-3
DHCP server IP address 21-9
forward delay time 21-10
maximum number of hops 21-11
standard forwarding option 21-11
directed broadcast 15-23
DoS 15-23
enabling traps 15-27
setting decay value 15-27
setting penalty values 15-26
Setting Port Scan Penalty Value 15-27
DVMRP 24-8
dynamic link aggregation 8-1, 10-1
application examples 8-4, 8-27, 9-5, 10-5
defaults 8-3, 9-4, 10-4, 14-4
group actor administrative key 8-14
group actor system ID 8-15
group actor system priority 8-14
group administrative state 8-13
group partner administrative key 8-15
group partner system ID 8-16
group partner system priority 8-16
groups 8-9
assigning ports 8-10
creating groups 8-9
deleting groups 8-10
group names 8-13
removing ports 8-11
LACPDU bit settings 8-17, 8-21
LACPDU frames 8-17, 8-21
Link Aggregation Control Protocol (LACP) 8-6
MAC address 8-15, 8-16, 8-19, 8-23
port actor administrative priority 8-19
port actor port priority 8-20
port actor system administrative states 8-17
port actor system ID 8-19
port partner administrative key 8-23
port partner administrative priority 8-25
port partner administrative state 8-21
port partner administrative system ID 8-23
port partner administrative system priority 8-24
port partner port administrative status 8-25
ports 8-10