Omron MX2 - Page 342

320
Parameter Settings for Keypad Entry Section C-2
C056 Over/under-torque level
(Reverse regen. mode)
100. ✓
C057 Over/under-torque level
(Reverse powering mode)
100. ✓
C058 Over/under-torque level
(Forward regen. mode)
100. ✓
C059 Signal output mode of Over/under
torque
01 ✓
C061 Electronic thermal warning level 90. ✓
C063 Zero speed detection level 0.00 ✓
C064 Heat sink overheat warning 100. ✓
C071 Communication speed 05 ✓
C072 Modbus address 1. ✓
C074 Communication parity 00 ✓
C075 Communication stop bit 1 ✓
C076 Communication error select 02 ✓
C077 Communication error time-out 0.00 ✓
C078 Communication wait time 0. ✓
C081 [O] input span calibration 100.0 ✓
C082 [OI] input span calibration 100.0 ✓
C085 Thermistor input (PTC) span
calibration
100. ✓
C091 Debug mode enable 00 ✓
C096 Communication selection 00. ✕
C098 EzCOM start adr. of master 1. ✕
C099 EzCOM end adr. of master 1. ✕
C100 EzCOM starting trigger 00 ✕
C101 Up/Down memory mode selection 00 ✓
C102 Reset selection 00 ✓
C103 Restart mode after reset 00 ✓
C104 UP/DWN clear mode 00 ✓
C105 EO gain adjustment 100. ✓
C106 AM gain adjustment 100. ✓
C109 AM bias adjustment 0. ✓
C111 Overload warning level 2 Rated current ✓
C130 Output [11] on-delay time 0.0 ✓
C131 Output [11] off-delay time 0.0 ✓
C132 Output [12] on-delay time 0.0 ✓
C133 Output [12] off-delay time 0.0 ✓
C140 Relay output on-delay time 0.0 ✓
C141 Relay output off-delay time 00 ✓
C142 Logic output 1 operand A 00 ✓
C143 Logic output 1 operand B 00 ✓
C144 Logic output 1 operator 00 ✓
C145 Logic output 2 operand A 00 ✓
C146 Logic output 2 operand B 00 ✓
C147 Logic output 2 operator 00 ✓
C148 Logic output 3 operand A 00 ✓
C149 Logic output 3 operand B 00 ✓
C150 Logic output 3 operator 00 ✓
C160 Input [1] response time 1.
✓
"C" Group Parameters Default Setting B031=10 User
Setting
Func.
Code
Name (EU)