50
Using the Front Panel Keypad Section 2-5
[Setting example]
After power ON, changing from 0.00 display to change the b083
(carrier frequency) data.
Note Function code bxxx are for monitor and not possible to change.
Function codes Fxxx other than Fxxx are reflected on the performance just
after changing the data (before pressing key), and there will be
no blinking.
Note Keep pressing for more than 1 second leads to d001 display, regardless the
display situation. But note that the display will circulates while keep pressing
the key because of the original function of the key.
(e.g. F001 –> A001 –> b001 –> C001 –> … –> displays 50.00 after 1 second)
Data of d001 will be shown on the
display after the rst power ON
Press
Press
Press
Press Up key to change increase function code (b001 –> b083).
Press
Press
: Fix and stores the data and moves back to the function code
: Cancels the change and moves back to the function code
When data is changed, the display
starts blinking, which means that new
data has not been activated yet.
Press up key to increase the
data (5
.0 –> 12.0)
key to move on to the function group F001
key twice to move on to the function group b001.
key to display the data of b083
key to show
the function code
key to set
and save the data
d001
F001
b001
b083
0.00
When a function code is shown… When a data is shown…
key Move on to the next function group Cancels the change and moves
back to the function code
key Move on to the data display Fix and stores the data and
moves back to the function code
key Increase function code Increase data value
key Decrease function code Decrease data value
To Next Page
Loading...
Need help?
General
