– 126 – NWA-008845-001 Rev.5.0
32ch1002.fm
When the signal pattern of the called number sent from T1 network is as shown below, assign the following
data, if required.
Called Number=NPA + NNX + Called Station Number
NOTE: FGD-Format and ANI-Format are:
HARDWARE REQUIRED
DTI card
MFR card
DESCRIPTION DATA
Assign the Digit Addition/Deletion on the
incoming calls.
•
(1)
(2)
Y=17 Digit Addition/Deletion Assignment
00-63: Trunk Route No.
00-09: “0” add -“9” add
10 : 2-digit addition (CM50 Y=00>0)
11 : 1 digit deletion
12 : 2 digits deletion
15 : Addition/deletion is not performed
Assign the access code for LCR Group 0-3. •
(1)
(2)
Y=0-3 Numbering Plan Group 0-3
X-XXXX: Access Code
A126: LCR Group 0
A127: LCR Group 1
A128: LCR Group 2
A129: LCR Group 3
Assign an area code for Intra-Office
Termination.
•
(1)
(2)
Y=4005-4007 Area Code Development
No. 5-7
X-XXXXXXXX: Area Code, 1-8 digits
8000: Intra-Office Termination
SIGNAL PATTERN CALLED NUMBER ANI
FGD-Format MF Signal MF Signal
ANI-Format DP Signal MF Signal
START
CM35
CM20
CM8A
END
AUTOMATIC NUMBER IDENTIFICATION (ANI)
To Next Page
Loading...