– 143 – NWA-008845-001 Rev.5.0
32ch1003.fm
DESCRIPTION DATA
Specify the timing of Call Forwarding-No An-
swer for a trunk incoming call.
•
(1)
(2)
Y=0
01 : Timing for a trunk incoming call
100: Timing for a trunk incoming call
[Series 3100 software required]
01-30: 4-120 seconds
(4 second increments)
If no data is set, the default setting is 32-36
seconds.
Specify the timing of Call Forwarding-No An-
swer for an internal call or an assisted call.
•
(1)
(2)
Y=0
15 : Timing for an internal call or an assist-
ed call
101: Timing for an internal call or an assist-
ed call
[Series 3100 software required]
01-30: 4-120 seconds
(4 second increments)
If no data is set, the default setting is 32-36
seconds.
To apply this feature to incoming calls, set the
trunk route combinations for Tandem Connec-
tion.
•
(1)
(2)
Y=05
00-63: Trunk Route No. NOTE
1 : Release signal arrives NOTE
NOTE: For Resident System Programming,
refer to the Command Manual.
•
(1)
(2)
Y=0
Incoming Trunk Route No. + Outgoing
Trunk Route No. assigned by CM35 Y=05
0: Allow
Specify the setting method for Call Forward-
ing-No Answer-Outside.
(1)
(2)
222
0 : Setting when the station goes on hook/
when receiving Service Set Tone
(ORT time out)
1 : Setting when receiving Service Set
Tone (ORT time out)
Assign whether an extension can set a destina-
tion of Call Forwarding-No Answer-Outside
by entering only a trunk access code.
(1)
(2)
386
0 : Restricted
1 : Allowed
A
CM41
CM35
CM36
CM08
B
CALL FORWARDING
CALL FORWARDING-NO ANSWER
To Next Page
Loading...