– 159 – NWA-008845-001 Rev.5.0
32ch1003.fm
DESCRIPTION DATA
Specify the timing of Call Forwarding-No
Answer.
•
(1)
(2)
Y=46
X-XXXXXXXX: My Line No.
0 : As per CM41 Y=0>100, 101 or CME6
Y=07, 08 NOTE
1 : As per CM41 Y=0>01, 15
NOTE: When CME6 Y=07, 08 are set, the timing on a station basis (CME6 Y=07, 08) is effective.
When CME6 Y=07, 08 are not set, the timing on a system basis (CM41 Y=0>100, 101) is
effective.
[Series 3200 R6.2 software required]
Specify the timing of Call Forwarding-No
Answer for a trunk incoming call.
•
(1)
(2)
Y=0
01 : Timing for a trunk incoming call
100: Timing for a trunk incoming call
[Series 3100 software required]
01-30: 4-120 seconds
(4 second increments)
If no data is set, the default setting is 32-36
seconds.
Specify the timing of Call Forwarding-No
Answer for an internal call or an assisted call.
•
(1)
(2)
Y=0
15 : Timing for an internal call or an assist-
ed call
101: Timing for an internal call or an assist-
ed call
[Series 3100 software required]
01-30: 4-120 seconds
(4 second increments)
If no data is set, the default setting is 32-36
seconds.
To apply this feature to incoming calls, set the
trunk route combinations for Tandem Connec-
tion.
•
(1)
(2)
Y=05
00-63: Trunk Route No. NOTE
1 : Release signal arrives NOTE
NOTE: For Resident System Programming,
refer to the Command Manual.
•
(1)
(2)
Y=0
Incoming Trunk Route No. + Outgoing
Trunk Route No. assigned by CM35 Y=05
0: Allow
A
CM13
CM41
CM35
CM36
B
CALL FORWARDING
SPLIT CALL FORWARDING-NO ANSWER
To Next Page
Loading...