– 178 – NWA-008845-001 Rev.5.0
32ch1003.fm
DESCRIPTION DATA
Assign an Remote Site number that accommo-
dates CIR trunk to the AP number assigned by
CM05 Y=0.
•
(1)
(2)
Y=8
04-15, 64-93: AP No.
XX 99
XX: 01-30: Remote Site No.
XX 9915 NOTE 2
[Series 3800 software required]
XX : 01-30: Remote Site No. NOTE 3
99 : AP card No.
NONE : No data
NOTE 1: This data should be assigned only when PN-4RSTC-A card is accommodated in Remote
site.
NOTE 2: All the SENSE switch on PN-4RSTC-A card should be assigned to 15 when AP No. 64-93
is assigned for PN-4RSTC-A card accommodated in Remote site.
Assign any one number from AP numbers 64-93 with CM05 per PN-4RSTC-A card (same
even if the site that accommodates the PN-4RSTC-A cards is different).
NOTE 3: The Remote site number 01-15 can be assigned when the system is using Series 3200 R6.2
to 3300 software.
Specify the type of the mounting card for Re-
mote Site to the AP number assigned by CM05
Y=0.
NOTE: Set the second data to 1 only when
the AP number is assigned by CM05
Y=0 which is accommodated in Re-
mote site.
•
(1)
(2)
Y=6
04-15, 64-93: AP No.
1 : Remote Site
3 : AP card
Assign the MF Receiver trunk number to each
circuit of the CIR Trunk.
•
(1)
(2)
Y=04
00-15: MF Receiver Trunk No.
XX Z
XX: AP No. assigned by CM05
Z : 0-3: Circuit No.
Assign requesting of ANI/CALLER ID Signal
from network when an incoming call
terminates.
(1)
(2)
472: Request for ANI/CALLER ID
Signal
0: Available
A
CM05
INITIAL
INITIAL
CM06
INITIAL
CM08
B
NOVEMBER/15/2006
CALLER ID CLASS
To Next Page
Loading...