– 179 – NWA-008845-001 Rev.5.0
32ch1003.fm
(3) Memory Clear for CIR Trunk (PN-4RSTC)
Clearing all data in memory for calling number development is necessary before assigning the
calling number development data by CMDC and CMDB.
NOTE 1: The following data assignment is required only when using PN-4RSTC as a CIR Trunk.
NOTE 2: Before memory clear, set the SW1-1 to SW1-4 on the CIR Trunk to all ON (Make-busy) and after
memory clear, restore them to OFF.
DESCRIPTION DATA
Assign the sending method of calling number
from the network, to the AP number assigned
by CM05.
•
(1)
(2)
Y=07
04-15, 64-93: AP No.
0 : CALLER ID (CLASS SM)
7: MFC-R2
Assign the CALLER ID Receiver to each AP
number (0-3) of the CIR Trunk.
•
(1)
(2)
Y=2
0-3: AP No. NOTE
3 : All circuits assigned as Receiver
NOTE: AP numbers 0-3 correspond to the AP
numbers assigned by CM05 (04-15):
CM31 Y=2
CM05 Y=0
AP Number 0: AP Number X
AP Number 1: AP Number Y
AP Number 2: AP Number Z
AP Number 3: AP Number W
(X<Y<Z<W)
DESCRIPTION DATA
Clear all memory for CMDC and CMDB. •
(1)
(2)
Y=90 All Memory Clear
0000
CCC
B
CMAA
CM31
INITIAL
END
START
CMDB
END
NOVEMBER/15/2006
CALLER ID CLASS
To Next Page
Loading...