Philips Sopho 2000 IPS - Page 198

– 180 – NWA-008845-001 Rev.5.0
32ch1003.fm
If required, clear the partial memory using the commands shown below.
NOTE 1: The following data assignment is required only when using PN-4RSTC as a CIR Trunk.
NOTE 2: Before memory clear, set the SW1-1 to SW1-4 on the CIR Trunk to all ON (Make-busy) and after
memory clear, restore them to OFF.
(4) CALLER ID Development Data Assignment
NOTE: The following data assignment is required only when using PN-4RSTC as a CIR Trunk.
DESCRIPTION DATA
Clear the memory for the calling number
Development Table number assigned by
CMDC and the calling number development
data assigned by CMDB.
•
(1)
(2)
Y=91 Partial Memory Clear
0001
CCC
Clear the memory for calling number
development data assigned by CMDB.
•
(1)
(2)
Y=92 Partial Memory Clear
0002
CCC
DESCRIPTION DATA
Assign the Development Table for the calling
number sent from the network.
•
(1)
(2)
Y=00-63 Trunk Tenant No.
Calling No.
0 -1499: Development Table No. 0-1499
Assign whether the Trunk Tenant number is
effective for developing the calling number, or
not.
•
(1)
(2)
Y=30
0: Trunk Tenant No. Development
0 : Ignore actual Trunk Tenant and use the
Development Table for Trunk Tenant
00 (CMDC Y=00)
1 : Execute actual Trunk Tenant and use
the Development Table for each Trunk
Tenant (CMDC Y=00-63)
By character code, assign the name displayed,
if required.
A maximum of 14 characters are available for
the name display.
•
(1)
(2)
Y=00 Name Assignment
0-1499: Development Table No.
Character Code
See APPENDIX B: Character Code Table.
Page B2
START
CMDB
END
START
CMDC
CMDB
A
JULY/01/2006
CALLER ID CLASS