– 181 – NWA-008845-001 Rev.5.0
32ch1003.fm
DESCRIPTION DATA
Assign the destination station for Day Mode/
Night Mode, if required. A maximum of 12
digits are available.
NOTE: If assigning the destination station
number as below, the terminating
system overrides CM30 Y=02/03 for
the selected Development Table.
****02: Trunk-Direct Appearances
****03: Trunk-Direct Appearances + TAS
****04: Direct-in Termination
****09: Automated Attendant
****10: Attendant Console + TAS
****11: Attendant Console + Trunk-Direct Appearances
****12: Attendant Console + Trunk-Direct Appearances +
TAS
****14: Termination to Attendant Console
****16: Direct Inward System Access (DISA)
****31: DID, Tie Line, and any call which is not handled by
the PBX
NOTE: The destination station number can
also be an LCR access code plus
outside telephone number.
•
•
(1)
(2)
Y=01 Day Mode
Y=02 Night Mode
0-1499: Development Table No.
Destination Station No. (Maximum 12
digits)
Specify the ringing tone for each calling
number, if required.
•
(1)
(2)
Y=04 Ringing Tone Assignment
0-1499: Development Table No.
0 : Depends on CM35 Y=33
1 : Not used
2 : Internal Ringing Tone
3 : External Ringing Tone
Specify which is displayed on the LCD, when
receiving both the calling number and the
name from network on incoming call.
•
(1)
(2)
Y=05 Calling Number/Name Display
0-1499: Development Table No.
0 : Calling Number Display
1 : Calling Name Display
Specify whether the Call Waiting is set for
each calling number or not.
•
(1)
(2)
Y=06 Call Waiting
0-1499: Development Table No.
0 : Not available
1 : Available
NOTE: This data is effective when the
2nd data of CM35 Y=59 is 1.
A
CMDB
B
CALLER ID CLASS
To Next Page
Loading...