– 324 – NWA-008845-001 Rev.5.0
32ch1006.fm
NOTE: For the Trunk Restriction Class, refer to CLASS OF SERVICE. Page 211
DESCRIPTION DATA
According to the characteristics of each C.O.
line, assign the data for DP/DTMF Sender to
each route.
For the details of the command, refer to the
Command Manual.
NOTE: For Resident System Program, refer
to the Command Manual.
•
•
•
•
•
•
•
•
Y=20 Sender start condition
Y=21 Sender Prepause Timing
Y=23 DP-Inter Digital Pause
Y=24 DTMF-Inter Digital Pause
Y=25 DP-Make Ratio
Y=26 DTMF Signal Width
Y=45 DP Sender Release Timing
Y=46 DTMF Sender Release Timing
Specify the timing for Interdigit Pause on out-
going C.O. call.
•
(1)
(2)
Y=0
27
03-14: 3-14 seconds
(1 second increments)
If no data is set, the default setting is 7 sec-
onds.
Assign the access code to each route. •
(1)
(2)
Y=0-3 Numbering Plan Group 0-3
X-XXXX: Access Code
100-163: Trunk Route No. 00-63
Assign the trunk appearance line key on a
D
term
, if provided.
•
(1)
(2)
Y=00
My Line No. + + Key No.
D000-D255: Trunk No.
B
CM35
CM41
CM20
CM90
,
END
DIRECT OUTWARD DIALING (DOD)
To Next Page
Loading...