Philips Sopho 2000 IPS - Page 360

– 342 – NWA-008845-001 Rev.5.0
32ch1006.fm
DESCRIPTION DATA
Specify the lamp color for an incoming exter-
nal call.
NOTE 1: The lamp color for incoming inter-
nal calls is red (120 IPM flashing).
NOTE 2: For indicating the termination of a
transferred external incoming call,
the flashing lamp color depends on
CM08>137.
•
(1)
(2)
Y=32
00-63: Trunk Route No.
0 : Green (120 IPM)
1 : Red (120 IPM)
Specify the interval of ringing tones to a D
term
on an incoming call.
NOTE: For SLT, Internal Ringing is ap-
plied. For D
term
, the special ring-
ing; 0.25 seconds ON-0.25 seconds
OFF 0.25 seconds ON-0.25 seconds
OFF is applied.
•
(1)
(2)
Y=33
00-63: Trunk Route No.
0:ReringNOTE
1 : Special Ringing
2 : Internal Ringing
3 : External Ringing
(See Interval of Ringing Tones by
CM08>392/CM08>396/
CM08>397. Page 337)
Specify the Ringer Tone Pattern of the D
term
to
each trunk route.
•
(1)
(2)
Y=34, 164
00-63: Trunk Route No.
See the table below.
[Series 3200 R6.1 software required]
A
CM35
Y=34 Y=164: 0 Y=164: 1
0 Ringer Tone Pattern 3 Ringer Tone Pattern 0
1 Ringer Tone Pattern 6 Ringer Tone Pattern 1
2 Ringer Tone Pattern 5 Ringer Tone Pattern 2
3 Ringer Tone Pattern 4 Ringer Tone Pattern 7
B
DISTINCTIVE RINGING