– 476 – NWA-008845-001 Rev.5.0
32ch1008.fm
To store the calling number automatically when the station call via CCIS is abandoned, do the following
programming:
[Series 3800 software required]
HARDWARE REQUIRED
Single-Line Telephone with MW Lamp
8LC or 4LCD card
DESCRIPTION DATA
Assign the data so as to store the calling num-
ber automatically when the station call via
CCIS is abandoned.
(1)
(2)
583
0: To store
Assign the Pattern number for adding an
access code for outgoing call to the calling
number stored by Message Reminder when
terminating a tandem call via CCIS.
•
(1)
(2)
Y=279
00-63: Trunk Route No.
0-7 : Pattern No. 0-7
NONE : No data
Provide the trunk route with the CID Call
Back.
•
(1)
(2)
Y=150
00-63: Trunk Route No.
0: To provide
Assign the Pattern number for adding an
access code for outgoing call to the calling
number stored by Message Reminder when
terminating a tandem call via CCIS.
•
(1)
(2)
Y=11
0-7: Pattern No. 0-7 assigned by CM35
Y=279
X-XXXXXX: Access Code for outgoing
call
X: 0-9, A (*), B (#)
START
CM08
CM35
CM50
END
NOVEMBER/15/2006
MESSAGE REMINDER
To Next Page
Loading...