Philips Sopho 2000 IPS - Page 493

– 475 – NWA-008845-001 Rev.5.0
32ch1008.fm
To provide CID Call Back, add the following programming:
To display the date when searching a message set by Message Reminder from D
term
, do the following pro-
gramming:
[Series 3800 software required]
DESCRIPTION DATA
Allow CID Call Back in Service Restriction
Class A assigned by CM12 Y=02.
•
(1)
(2)
Y=126
00-15: Service Restriction Class A as-
signed by CM12 Y=02
0 : Allow
1 : Restricted
Provide the trunk route with the CID Call
Back.
•
(1)
(2)
Y=150
00-63: Trunk Route No.
0: To provide
1: Not Provided
Assign the number of memory block which is
used for CID Call Back for each D
term
station.
•
(1)
(2)
Y=38
X-XXXXXXXX: Station No.
XX ZZ
XX: 00-15 : Service Restriction Class A
XXXX ZZ
XXXX : 0000-1016: Start Block No.
ZZ : Number of Memory Block for
CID Call Back
01: 8 blocks
02: 16 blocks
03: 24 blocks
NONE : 4 blocks
DESCRIPTION DATA
Provide the date display when searching a
message set by Message Reminder from D
term
.
NOTE: When this command is set to 0, the
time is displayed by 24-Hour, al-
though CM08>280 is set to 1.
(1)
(2)
582
0: To provide
START
CM15
CM35
CM12
END
START
CM08
END
NOVEMBER/15/2006
MESSAGE REMINDER