– 568 – NWA-008845-001 Rev.5.0
32ch1009.fm
To provide the Digital Single Line on D
term
, do the following programming.
DESCRIPTION DATA
Provide Trunk-Direct Appearances to the
trunk number.
•
(1)
(2)
Y=18
000-255: Trunk No.
0: To provide
DESCRIPTION DATA
Assign Service Restriction Class C to each sta-
tion.
•
(1)
(2)
Y=07
X-XXXXXXXX: Station No.
00-15 : Service Restriction Class C
Disable Dial Tone Activation when pressing
one-touch speed key while terminal is idle.
•
(1)
(2)
Y=87 One-Touch activates DT when Ter-
minal Idle
00-15: Service Restriction Class C
assigned by CM12 Y=07
0 : Remain Idle
1 : Off Hook and Dial Tone
Assign and delete feature keys.
NOTE: Use Key number 93 for Redial key.
Use Key number 96 for Flash key.
Prime line should be assigned to Key 9.
Digital Single Line is a D
term
and can use any
key assigned in CM90. However, the Digital
Single Line Terminal has no LEDs, speaker, or
microphone. Assign any features that can be
used without these devices.
•
(1)
(2)
Y=00 Key Data
X-XXXXXXXX: My Line No. + +
Key No.
F1100-F1199: Station Speed Dialing 00-99
F1012 : Conference key
This key is required to pro-
gram speed dial keys.
F0069 : Last number redial (Key No.
93)
F1004 : Transfer key (Key
No. 96)
Assign prime line to My Line. (1)
(2)
X-XXXXXXXX: My Line No.
X-XXXXXXXX: Prime Line
B
CM30
END
START
CM12
CM15
CM90
,
CNF
TRF
CM93
END
JUNE/01/2007
PROPRIETARY MULTILINE TERMINAL
To Next Page
Loading...