– 712 – NWA-008845-001 Rev.5.0
32ch1011.fm
To provide Trunk-Direct Appearances on ISDN BRI trunk:
[Series 3800 software required]
NOTE: ISDN Trunk Connection is required before setting following programming. Refer to “ISDN Sys-
tem Manual”.
DESCRIPTION DATA
Assign the terminating system for required
C.O. trunks to Trunk-Direct Appearances.
•
•
•
•
(1)
(2)
Y=02 Day Mode
Y=03 Night Mode
Y=40 Mode A
Y=41 Mode B
000-255: Trunk No.
02 : Trunk-Direct Appearances
03 : Trunk-Direct Appearances+TAS
06 : Direct-In Termination+Trunk-Direct
Appearances
11 : Attendant Console+Trunk-Direct
Appearance
12 : Attendant Console+Trunk-Direct
Appearance+TAS
31 : DID, Tie Line and the call which is
not handled by the PBX
Provide the Trunk-Direct Appearances feature
to the required C.O. trunk assigned by CM30
Y=02.
•
(1)
(2)
Y=18
000-255: Trunk No.
0: To provide
Assign the Number Conversion Block number
for Development Table 0.
•
(1)
(2)
Y=00
X-XXXX: DID No.
000-999 : Number Conversion Block No.
NONE : No data
Assign the Number Conversion Block number
for Development Table 1.
•
(1)
(2)
Y=90
X-XXXXXXXX: DID No.
000-999 : Number Conversion Block No.
NONE : No data
START
CM30
CM76
A
JUNE/01/2007
TRUNK-DIRECT APPEARANCES
To Next Page
Loading...