– 713 – NWA-008845-001 Rev.5.0
32ch1011.fm
DESCRIPTION DATA
Assign the data for interpreting the digits re-
ceived.
•
•
•
•
(1)
(2)
Y=01 Day Mode
Y=02 Night Mode
Y=03 Mode A
Y=04 Mode B
000-999: Number Conversion Block No.
assigned by CM76 Y=00/90
X-XXXXXXXX: Station No. to be termi-
nated
DXX: Change Terminating System to:
D02: Trunk-Direct Appearances
D03: Trunk-Direct Appearances+
TAS
D06: Direct-In Termination+
Trunk-Direct Appearances
Assign a Trunk-Direct Appearances key to
each D
term
, as required.
•
(1)
(2)
Y=00
My Line No. + + Key No.
D000-D255: Trunk No.
Assign a trunk access code sent to SMDR for
outgoing call.
NOTE: This command is effective when
CM35 Y=189 is not assigned.
•
(1)
(2)
Y=44
00-63: Trunk Route No.
00-99: Trunk Access Code
Assign a trunk access code for Trunk-Direct
Appearances Multiline Operation.
•
(1)
(2)
Y=189
00-63: Trunk Route No.
X-XX: Trunk Access Code
X=0-9, A (*), B (#)
Specify the Timing Start when making ISDN
call from a Single Line Telephone (PB/DP),
D
term
or Attendant Console.
•
(1)
(2)
Y=0
50
03-14: 3-14 seconds
(1 second increment)
If no data is set, the default setting is 10 seconds.
Specify the ORT timer when sending LCR.
NOTE: Second data 02 is available for
Series 3600 or later.
•
(1)
(2)
Y=0
111
02-15: 2-15 seconds
(1 second increment)
If no data is set, the default setting is 7 seconds.
A
CM76
CM90
,
CM35
CM41
B
NOVEMBER/15/2006
TRUNK-DIRECT APPEARANCES
To Next Page
Loading...