– 722 – NWA-008845-001 Rev.5.0
32ch1011.fm
DESCRIPTION DATA
Specify the processing for an incoming call
when all UCD stations are busy.
(1)
(2)
212
0 : Busy Tone Connection
1: Queuing
Specify the processing for a held call after set-
ting the UCD Busy Out.
(1)
(2)
214: For the held call from Tie Line
0 : Reconnected by Switch Hook Flash
1 : Disconnected
(1)
(2)
215: For the held call from C.O. Line
0 : Reconnected by Switch Hook Flash
1 : Disconnected
Specify that the transferred C.O. call from a
station or an attendant is placed into queuing
mode when all UCD stations are busy.
NOTE: This data is only effective when
CM08>212 is set to 1.
(1)
(2)
227
0 : The call is placed into queuing mode
NOTE
1 : Recall to the transferring station when
the call is transferred from station, or
Attendant Camp-On is set when the
call is transferred from Attendant
Enable the UCD Busy Out set and reset from
the secondary extension.
(1)
(2)
442
0 : Available
1 : Not available
B
CM08
END
UNIFORM CALL DISTRIBUTION (UCD)
To Next Page
Loading...