– 749 – NWA-008845-001 Rev.5.0
32ch1011.fm
DESCRIPTION DATA
Assign the access code for MW lamp set/reset
from a VMS station port.
•
(1)
(2)
Y=0-3 Numbering Plan Group 0-3
X-XXXX: Access code
A040: Set
A041: Reset
Assign the access code to retrieve a message
from the VMS and search Message Reminder/
Message Waiting.
•
(1)
(2)
Y=0-3 Numbering Plan Group 0-3
X-XXXX: Access code
A146: Search
A147: Retrieve
Assign the access code to be sent out to a VMS
after/before a Mail Box number, if required.
NOTE 1: “C” or “D” should not be assigned
as the first digit of an access code, to
insert prepause timing. Prepause
timing is assigned by CM41
Y=0>44.
NOTE 2: If “C” is inserted in the access code,
it can be used as a pause (1.5 sec-
onds). To provide a programmable
pause, insert “D” instead of “C”
(Programmable Pause: CM41
Y=0>38).
•
(1)
(2)
Y=00
3: Access Code to be sent out before a Mail
Box No.
NOTE 1
4: Access Code to be sent out after a Mail
Box No.
XX-XXXX: Access code to be sent out to a
VMS
X: 0-9, A (*), B (#), C/D (Pause)
NOTE 2
NONE : Not sent out
Specify the prepause timing, DTMF signal
width, and Inter-digital pause for VMS.
•
(1)
(2)
Y=0
44: Prepause Timing
00-12, 13: 0-12, 0.5 seconds
If no data is set, the default setting is 1 second.
Specify the DTMF signal width for VMS. •
(1)
(2)
Y=0
48
01: 64 ms.
02: 128 ms.
If no data is set, the default setting is 128 ms.
Specify the DTMF inter-digital pause for
VMS.
•
(1)
(2)
Y=0
49
01: 32 ms. 05: 120 ms
02: 64 ms. 06: 160 ms.
03: 80 ms. 07: 200 ms.
04: 100 ms. 08: 240 ms.
If no data is set, the default setting is 160 ms.
A
CM20
CM50
CM41
B
VOICE MAIL INTEGRATION
To Next Page
Loading...