EasyManua.ls Logo

R&S FSW Series - Page 1203

R&S FSW Series
1450 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Remote Commands
R&S
®
FSW
1203User Manual 1173.9411.02 ─ 43
Basic Frequency Sweep Measurement for Marker Function Examples
Since markers can only be placed on an existing trace, the following example provides
a simple frequency sweep measurement to be used as a basis for the subsequent
marker function scripts.
//-------------- Configuring the basic frequency sweep -------------
*RST
//Resets the instrument
INIT:CONT OFF
//Selects single sweep mode.
FREQ:CENT 100MHz
//Defines the center frequency
FREQ:SPAN 200MHz
//Sets the span to 100 MHz on either side of the center frequency.
DISP:TRAC1:Y:RLEV 0dBm
//Sets the reference level to 0 dBm.
//------- Performing the measurement -------------------------
INIT;*WAI
//Performs a measurement and waits for it to end
Example: Using a Fixed Reference Marker
This example demonstrates how to configure and use reference markers in a basic
spectrum measurement in a remote environment. It assumes that the basic frequency
sweep described in "Basic Frequency Sweep Measurement for Marker Function Exam-
ples" on page 1203 has been performed and thus does not begin by presetting the
instrument.
//-----------Configuring the reference marker ------------
//Activate a fixed reference marker. It is set to the current maximum of trace 1.
CALC:DELT:FUNC:FIX ON
//Set the reference frequency to 128 MHz.
CALC:DELT:FUNC:FIX:RPO:X 128 MHZ
//Set the reference level to +30 dBm.
CALC:DELT:FUNC:FIX:RPO:Y 30 DBM
//Use the fixed reference marker as a reference for deltamarker 2
CALC:DELT2:MREF FIX
//Reset the reference marker to the current maximum of trace 1
CALC:DELT:FUNC:FIX:RPO:MAX
//Query the new position of the reference marker
CALC:DELT:FUNC:FIX:RPO:X?
CALC:DELT:FUNC:FIX:RPO:Y?
Example: Obtaining a Marker Peak List
This example demonstrates how to obtain a marker peak list in a basic spectrum mea-
surement in a remote environment. It assumes that the basic frequency sweep descri-
bed in "Basic Frequency Sweep Measurement for Marker Function Examples"
Analyzing Measurements (Basics)

Table of Contents

Related product manuals