R&S FSW Series - Page 1233

Remote Commands
R&S
®
FSW
1233User Manual 1173.9411.02 ─ 43
Optional: determines whether disconnection is forced or not
1 | ON
Disconnection is forced.
0 | OFF
Disconnect only if not in use.
*RST: 0
MMEMory:NETWork:MAP <arg0>, <arg1>[, <arg2>, <arg3>, <arg4>]
This command maps a drive to a server or server directory of the network.
Note that you have to allow sharing for a server or folder in Microsoft networks first.
Parameters:
<arg0> String containing the drive name or path of the directory you
want to map.
<arg1> String containing the host name of the computer or the IP
address and the share name of the drive.
'<\host name or IP address\share name>'
<arg2> String containing a user name in the network.
The user name is optional.
<arg3> String containing the password corresponding to the <User-
Name>.
The password is optional.
<arg4> ON | OFF | 1 | 0
ON | 1
Reconnects at logon with the same user name.
OFF | 0
Does not reconnect at logon.
MMEMory:NETWork:UNUSeddrives
This command returns a list of unused network drives.
MMEMory:NETWork:USEDdrives [<arg0>]
This command returns a list of all network drives in use.
Parameters:
<arg0> You do not have to use the parameter. If you do not include the
parameter, the command returns a list of all drives in use.
This is the same behavior as if you were using the parameter
OFF.
ON | 1
Returns a list of all drives in use including the folder information.
OFF | 0
Returns a list of all drives in use.
Managing Settings and Results