R&S FSW Series - Page 125

Applications, Measurement Channels, and Operating Modes
R&S
®
FSW
125User Manual 1173.9411.02 ─ 43
The default application in Signal and Spectrum Analyzer mode is a Spectrum measure-
ment.
Switching between applications
When you switch to a new application, a set of parameters is passed on from the cur-
rent application to the new one:
●
center frequency and frequency offset
●
reference level and reference level offset
●
attenuation
After initial setup, the parameters for the measurement channel are stored upon exiting
and restored upon re-entering the channel. Thus, you can switch between applications
quickly and easily.
Switching the operating mode.....................................................................................125
Selecting an application.............................................................................................. 125
└ New Channel................................................................................................ 126
└ Replace Current Channel............................................................................. 126
└ Duplicate Current Channel............................................................................126
Closing an application.................................................................................................126
Switching the operating mode
To switch the operating mode, select the corresponding tab.
Remote command:
INSTrument:MODE on page 827
Selecting an application
To start a new or replace an existing application, select the corresponding button in the
correct tab.
Note: The measurement channels are labeled with their default name. If that name
already exists, a sequential number is added. You can change the name of the mea-
surement channel by double-tapping the name in the channel bar and entering a new
name.
For an overview of default names see INSTrument:LIST? on page 825.
Selecting the Operating Mode and Applications