R&S FSW Series - Page 1290

Remote Commands
R&S
®
FSW
1290User Manual 1173.9411.02 ─ 43
Example:
DISP:SBAR:OFF
Manual operation: See "Status Bar" on page 665
DISPlay:SKEYs[:STATe] <State>
This command turns the softkey bar on and off.
Parameters:
<State> ON | OFF | 0 | 1
*RST: 1
Example:
DISP:SKEY:OFF
Manual operation: See "Softkey Bar" on page 665
DISPlay:TBAR[:STATe] <State>
This command turns the toolbar on or off.
Parameters:
<State> ON | OFF | 1 | 0
*RST: 0
Example:
DISP:TBAR ON
Manual operation: See "Toolbar" on page 665
DISPlay:TOUChscreen[:STATe] <State>
This command controls the touch screen functionality.
Parameters:
<State> ON | FRAMe | OFF
ON | 1
Touch screen is active for entire screen
OFF | 0
Touch screen is inactivate for entire screen
FRAMe
Touch screen is inactivate for the diagram area of the screen,
but active for softkeys, toolbars and menus.
*RST: 1
Example:
DISP:TOUC:STAT ON
Manual operation: See "Deactivating and Activating the Touchscreen" on page 663
DISPlay[:WINDow<n>]:TIME <State>
This command adds or removes the date and time from the display.
Suffix:
<n>
.
irrelevant
Configuring the R&S FSW