R&S FSW Series User Manual

Remote Commands
R&S
®
FSW
1360User Manual 1173.9411.02 ─ 43
14.13.2.3 Special Behavior of Commands
Command Known Differences
ABORT Does not automatically set the command complete bit (bit 4) in the status byte. An addi-
tional DONE is required for that purpose.
ANNOT Only frequency axis annotation is affected.
AT AT DN/UP: Step size
CAL The CAL commands do not automatically set the command complete bit (bit 4) in the sta-
tus byte. An additional DONE command is required for that purpose.
CF Default value, range, step size
CR Default ratio Span/RBW
CT Formula for coupled sweep time
CV Default ratio RBW/VBW
DEMOD requires option R&S FSW-B3
DET DET? returns SAMP instead of SMP on the R&S FSW.
DET not automatically set the command complete bit (bit 4) in the status byte. An addi-
tional DONE is required for that purpose.
ERR? Deletes the error bit in the status register but always returns a '0' in response.
FA Default value, range, step size
FB Default value, range, step size
ID Query of instrument ID. The instrument ID defined in "SETUP > Network + Remote >
GPIB > Identification String" is returned.
M2 Default value, range, step size
M3 Default value, range, step size
MKACT Only marker 1 is supported as the active marker.
MKBW Default value
MKPT Step size
MKPX Step size
OL? Storage of instrument settings:
80 characters are returned as information on the instrument settings.
The contents of the 80 characters returned does not correspond to the original data con-
tents of the 8566A/8568A family.
OL Readout of instrument settings:
The 80 characters read by means of OL? are accepted as information on the correspond-
ing instrument settings.
The contents of the 80 characters read does not correspond to the original data contents
of the 8566A/8568A family.
RB Default value, range, step size
RL Default value, step size
Emulating Other Instruments' Commands

R&S FSW Series Specifications

General

Brand	R&S
Model	FSW Series
Category	Measuring Instruments
Language	English