Network and Remote Operation
R&S
®
FSW
770User Manual 1173.9411.02 ─ 43
Language Comment
8566B
8568A Command sets A and B are available. Command sets A and B differ in the rules
regarding the command structure.
8568A_DC Uses DC input coupling by default if supported by the instrument
8568B Command sets A and B are available. Command sets A and B differ in the rules
regarding the command structure.
8568B_DC Uses DC input coupling by default if supported by the instrument
8591E Compatible to 8594E
8594E Command sets A and B are available. Command sets A and B differ in the rules
regarding the command structure.
PSA89600
PSA
PXA
R&S FSEA
R&S FSEB
R&S FSEM
R&S FSEK
R&S FSP
R&S FSQ
R&S FSU
R&S FSV
Notes:
●
If you select a language other than "SCPI", the GPIB address is set to 18 if it was
20 before.
●
The Start/stop frequency, reference level and number of sweep points are adapted
to the selected instrument model.
●
For R&S FSP/FSQ/FSU emulation, HP commands are not automatically also
allowed. In this case, set HP Additional to ON.
●
When you switch between remote control languages, the following settings or
changes are made:
SCPI:
The instrument performs a PRESET.
8566A/B, 8568A/B, 8594E; FSEA, FSEB, FSEM; FSEK:
– The instrument performs a PRESET.
– The following instrument settings are changed:
GPIB Languages
To Next Page
Loading...
