R&S FSW Series User Manual

Network and Remote Operation
R&S
®
FSW
792User Manual 1173.9411.02 ─ 43
Remote command:
SYSTem:HPCoupling on page 1331
Wideband
This setting defines which option is returned when the *OPT? query is executed,
depending on the state of the wideband option.
It is only available for PSA89600 emulation.
"Off"
No wideband is used.
The option is indicated as "B7J".
"40 MHz"
The 40 MHz wideband is used.
The option is indicated as "B7J, 140".
"80 MHz"
The 80 MHz wideband is used.
The option is indicated as "B7J, 122".
Remote command:
SYSTem:PSA:WIDeband on page 1333
FSU/FSQ Preamplifier
This setting defines which option is returned when the *OPT? query is executed,
depending on the used preamplifier.
It is only available for FSU/FSQ emulation, and only if a preamplifier is used by the
R&S FSW (-B24/-B25 option).
Remote command:
SYSTem:PREamp on page 1333
HP Additional
Allows the use of HP commands in addition to SCPI commands for R&S
FSP/FSQ/FSU emulation (see Language).
Remote command:
SYSTem:HPADditional on page 1332
Revision String
Defines the response to the REV? query for the revision number.
(HP emulation only, see "Language" on page 790).
Max. 36 characters are allowed.
Remote command:
SYSTem:REVision[:STRing] on page 1334
Resetting the Factory Revision
Resets the response to the REV? query for the revision number to the factory default
(HP emulation only, see "Language" on page 790).
Remote command:
SYSTem:REVision:FACTory on page 1299
Network and Remote Control Settings

R&S FSW Series Specifications

General

Brand	R&S
Model	FSW Series
Category	Measuring Instruments
Language	English