CLI Reference Guide Cluster Management Configuration Commands
Show the basic information of
the cluster to which the device
belongs.
Show the candidate devices.
cluster discovery hop-count
Use this command to set the cluster topology discovery hop-count, namely the scope of the
topology discovery, the devices in this scope can be discovered by the commander to be the
candidate devices of the cluster. Use the no form of this command to restore it to the default value .
cluster discovery hop-count number
no cluster discovery hop-count
Scope (hop-count) of the cluster
discovery candidate device, in the range
of 1 to 7. The default value is 3.
Global configuration mode.
This command can be executed on the commander device only.
Input the show cluster command in the Privileged EXEC mode to
show the related configurations.
The following example sets the cluster topology discovery hop-count
as 4.
Ruijie(config)# cluster discovery hop-count 4
Show the basic information of
the cluster to which the device
belongs.
To Next Page
Loading...
