CLI Reference DHCPv6 Configuration Commands
show ipv6 dhcp binding
Use this command to show the address binding information for the DHCPv6 server.
show ipv6 dhcp binding [ ipv6-address ]
Set the IPv6 address or the prefix.
If the ipv6-address is not specified, all prefixes dynamically assigned to the client and IANA address
binding information are shown. If the ipv6-address is specified, the binding information for the
specified address is shown.
Ruijie# show ipv6 dhcp binding
Client DUID: 00:03:00:01:00:d0:f8:22:33:ac
IAPD: iaid 0, T1 1800, T2 2880
Prefix: 2001:20::/72
preferred lifetime 3600, valid lifetime 3600
expires at Jan 1 2008 2:23 (3600 seconds)
Use this command to show the DHCPv6 address conflicts.
To Next Page
Loading...
Need help?
General