CLI Reference Guide Syslog Configuration Commands
SYS CONFIG_I 5 1 Jul 6 10:29:57
SYS TOTAL 1
Enable the log statistics function.
Show the logs and related log configuration
parameters in the buffer.
Clear the logs in the buffer.
terminal monitor
Use this command to allow displaying log information on the current VTY window. Use the no form of
this command to disable displaying log information on the current VTY window.
terminal monitor
terminal no monitor
By default, it is not allowed to display log information on the VTY window.
This command is used to set temporary attributes of the current VTY. As a temporary attribute
setting, it will not be saved permanently. After VTY terminal session finishes, the system will restore
the default setting and this temporary attribute setting will lose effect. This command can be also
used on the console, but it does not take effect.
The following example configures to allow printing log information on the current VTY window:
Ruijie# terminal monitor
To Next Page
Loading...
Need help?
General