CLI Reference AAA Configuration Commands
AAA Configuration Commands
aaa authentication dot1x
Use this command to enable AAA authentication 802.1x and configure the 802.1x user authentication
method list. The no form of this command is used to delete the 802.1x user authentication method list.
aaa authentication dot1x {default | list-name} method1 [method2...]
no aaa authentication dot1x {default | list-name}
When this parameter is used, the following defined
802.1x user authentication method list is used as the
default method for user authentication.
Name of the 802.1x user authentication method list,
which could be any character string.
It must be one of the keywords listed in the following
table. One method list can contain up to four methods.
Use the local user name database for
authentication.
Do not perform authentication.
Use the server group for authentication.
At present, the RADIUS server group is
supported.
Global configuration mode.
If the AAA 802.1x security service is enabled on the device, users
must use AAA for 802.1x user authentication negotiation. You must
use aaa authentication dot1x to configure a default or optional
method list for 802.1x user authentication.
The next method can be used for authentication only when the
current method does not work.
The following example defines an AAA authentication method list
named RDS_D1X. In the authentication method list, first the RADIUS
To Next Page
Loading...
Need help?
General