Ruijie RG-S2600G-I Series - Show Dot1 X Summary

CLI Reference 802.1X Configuration Commands
show dot1x summary
Use this command to show information about the 802.1X authentication configuration table.
show dot1x summary
Parameter
Description
-
Defaults
-
Command Mode
Privileged mode
Usage Guide
-
Configuration
Examples
The following example shows how to display information about the 802.1x
authentication configuration table:
Ruijie# show dot1x summary
ID User MAC Interface VLAN Auth-State
Backend-State Port-Status User-Type Time
-------- ---------- -------------- --------- ---- ---------------
------------- ----------- --------- ------------------
2 ts-user 0023.aeaa.4286 Fa0/5 1 Authenticated
Idle Authed static 0days 0h 8m 8s
Ruijie#
Related Commands
Command
Description
dot1x auth-mode
It is used to set the 802.1x authentication mode.
dot1x max-req
It is used to set the maximum number of authentication
request re-transmission times.
dot1x port-control
auto
It is used to set a port to participate in authentication.
dot1x reauth-max
It is used to set the maximum number of applicant
re-authentication times.
dot1x
re-authentication
It is used to set whether periodic re-authentication is
required.
dot1x timeout
quiet-period
It is used to set the waiting time for re-authentication.
dot1x timeout
re-authperiod
It is used to set the re-authentication interval for an
applicant.
dot1x timeout
server-timeout
It is used to set the authentication timeout period between
a device and authentication server.
dot1x timeout
supp-timeout
It is used to set the authentication timeout period between
a device and applicants.
dot1x timeout
It is used to set the re-transmission interval.