CLI Reference AAA Configuration Commands
security server is used for authentication. If the RADIUS security
server does not respond, the local user database is used for
authentication.
Ruijie(config)# aaa authentication dot1x rds_d1x group radius local
Enable the AAA security service.
Associate a specific method list with
the 802.1x user.
Define a local user database.
aaa authentication enable
Use this command to enable AAA Enable authentication and configure the Enable authentication
method list. The no form of this command is used to delete the user authentication method list.
aaa authentication enable {default | list-name} method1 [method2...]
no aaa authentication enable default
When this parameter is used, the following defined
authentication method list is used as the default method
for Enable authentication.
It must be one of the keywords listed in the following
table. One method list can contain up to four methods.
Use the local user name database for
authentication.
Do not perform authentication.
Use the server group for authentication.
At present, the RADIUS and TACACS+
server groups are supported.
Global configuration mode.
If the AAA Enable authentication service is enabled on the device,
users must use AAA for Enable authentication negotiation. You must
use aaa authentication enable to configure a default or optional
To Next Page
Loading...
Need help?
General