CLI Reference REUP Configuration Commands
REUP Configuration Commands
link state track
Use this command to enable the link state track group. The no form of this command is used to disable a link state
track group
link state track [num]
no link state track [num]
Interface ID of the link aggregation group.
Global configuration mode.
First create a link state track group and then add a port into the specified
link state track group.
The following example shows how to create a link state track group:
Ruijie(config)# link state track 1
Add the port to the specified link state
track group.
link state group
Use this command to add the port into the specified link state track group. The no form of this command is used to
delete a port from the specified link state track group.
link state group num {upstream | downstream}
no link state group
ID of the link state track group.
Configure the port to be an upstream
To Next Page
Loading...
Need help?
General