Ruijie RG-S2600G-I Series - Qinq Configuration Commands

CLI ReferenceInterface Configuration Commands QinQ Configuration Commands
QinQ Configuration Commands
dot1q outer-vid vid register inner-vid v_list
Use this command to configure the add policy list of outer vid based on protocol on tunnel
port.
dot1q outer-vid vid register inner-vid v_list
no dot1q outer-vid vid register inner-vid v_list
Parameter
description
Parameter
Description
v_list
Inner vlan id list
vid
Outer vlan id list
no
Remove the settings.
Default
configuration
N/A.
Command
mode
Interface configuration mode.
Examples
Here is an example of configuring vid in the tag of input message as
4-22,adding the vid in the tag as 3:
Ruijie#configure
Ruijie(config)#interface gigabitEthernet 0/1
Ruijie(config-if)#switchport mode dot1q-tunnel
Ruijie(config-if)#dot1q outer-vid 3 register inner-vid 4-22
Ruijie(config-if)#end
Related
commands
Command
Description
show
registration-table
[interface intf-id]
Platform
description
The software version must be RGOS10.3 and later.
dot1q relay-vid vid translate local-vid v-list
Use this command to configure the modify policy list of outer vid based on protocol on
access,trunk,hybrid port.