CLI Reference IP Address Configuration Commands
Network address protocol, always
Internet.
The IP address corresponding to the
hardware address.
Age of the ARP cache record, in
minutes; If it is not locally or statically
configured, the value of the field is
represented with “-”.
Hardware address corresponding to
the IP address
The type of hardware address. The
value is ARPA for all Ethernet
addresses.
Interface associated with the IP
address.
This command is not supported on the Layer 2 switch.
Use this command to show the IP status information of an interface. The command
format is as follows:
show ip interface [ interface-type interface-number | brief ]
Specify interface number.
Show the brief configurations about the IP of the
layer-3 interface (including the interface primary ip,
secondary ip and interface status)
When an interface is available, RGOS will create a direct route in the routing table.
To Next Page
Loading...
Need help?
General