Ruijie RG-S2600G-I Series - Ipv6 Nd Dad Attempts

CLI Reference IPv6 Configuration Commands
defined in RFC4291.
interface-id
Network interface of the neighbor (including routed Port, L3 AP
interface, or SVI interface).
hardware-address
Hardware address of the neighbor. It shall be a 48-bit MAC address
in the format of XXXX.XXXX.XXXX, where “X” is a hexadecimal
number.
Defaults
No static neighbor is configured.
Command
Mode
Global configuration mode.
Usage Guide
Similar to the ARP command, the static neighbor can only be configured on an IPv6 protocol enabled
interface.
If the neighbor to be configured has been learned through NDP and has been stored in the neighbor
list, the dynamically generated neighbor will be automatically switched to a static one. The configured
static neighbor is always in the Reachable status.
Use clear ipv6 neighbors to clear all the neighbors dynamically learned through NDP.
Use show ipv6 neighbors to view the neighbor information.
Configuration
Examples
Ruijie(config)# ipv6 neighbor 2001::1 vlan 1 00d0.f811.1111
Related
Commands
Command
Description
show ipv6 neighbors
Show the neighbor information.
clear ipv6 neighbors
Clear the neighbors learned dynamically.
Platform
Description
N/A
ipv6 nd dad attempts
Use this command to set the number of the NS packets to be continuously sent for IPv6 address
collision check on the interface. Use the no form of this command to restore it to the default setting.
ipv6
no
Parameter
Description
Parameter
Description
value
Number of the NS packets. If it is set to 0, it indicates that the IPv6
address collision check is disabled on the interface. The range is 0 to
600.