CLI Reference Guide SNTP Configuration Commands
Global configuration mode.
The show sntp command shows the parameters of SNTP.
Note that the set interval will not take
effect immediately. To this end, execute
the sntp enable command after setting
the interval.
Ruijie(config)# sntp interval 3600
Show the SNTP configuration.
Synchronizes the software clock with
the hardware clock.
sntp server
Use this command to set the SNTP server. Since the SNTP protocol is completely compatible with the NTP
protocol, you can configure the SNTP server as the public NTP server on the Internet.
sntp server ip-address
no sntp server
The IP address of the NTP/SNTP server.
No NTP/SNTP server is configured.
Global configuration mode.
To Next Page
Loading...
Need help?
General