CLI Reference DHCPv6 Snooping Configuration Commands
DHCPv6 Snooping Configuration Commands
ipv6 dhcp snooping
Use this command to enable the DHCPv6 snooping function globally. The no form of this command will
disable the DHCPv6 snooping function globally.
[no] ipv6 dhcp snooping
Global configuration mode
Enable the DHCPv6 snooping function on the switch. You can use
the show ip dhcpv6 snooping command to view whether the
DHCPv6 snooping function is enabled.
The following is an example of enabling the DHCPv6 snooping
function.
Ruijie(config)# ipv6 dhcp snooping
View the configuration information
of DHCPv6 snooping.
This command is supported on all switches.
ipv6 dhcp snooping binding-delay
Use this command to add the DHCPv6 snooping binding delay entry to the hardware filtering list. The no
form of this command will disable the function.
ipv6 dhcp snooping binding-delay seconds
no ipv6 dhcp snooping binding-delay
To Next Page
Loading...
Need help?
General