CLI Reference DHCPv6 Snooping Configuration Commands
Set the binding delay time.
Global configuration mode.
By default, the DHCPv6 Snooping binding entries are added to the
hardware filtering list. With this command configured, if no IPv6
address conflict is detected within the specified time, the DHCPv6
Snooping binding entries are added to the hardware filtering list.
Ruijie(config)# ipv6 dhcp snooping binding-delay 10
This command is supported on all switches.
ipv6 dhcp snooping database write-delay
Use this command to configure the switch to write the dynamic user information of the DHCPv6
snooping binding database into the flash periodically. The no form of this command will disable this
function.
[no] ipv6 dhcp snooping database write-delay time
The interval at which the system writes the
dynamic user information of the DHCP
snooping database into the flash.
Global configuration mode.
This function can avoid loss of user information after restart. In that
case, users need to obtain IP addresses again for normal
communication.
The following is an example of setting interval at which the switch
To Next Page
Loading...
