CLI ReferenceInterface Configuration Commands GVRP Configuration Commands
GVRP Configuration Commands
Configuration Related Command
gvrp applicant state
Use this command to set the port advertising mode, which determines whether to allow sending the
GVRP advertisement on the port. Use the no form of this command to restore it to the default setting.
gvrp applicant state {normal | non-applicant}
no gvrp applicant state
Allow sending the GVRP advertisement on the port.
Interface configuration mode.
Use the show gvrp configuration to show the related
configurations.
Ruijie(config-if)# gvrp applicant state normal
Show the GVRP configurations.
gvrp dynamic-vlan-creation
Use this command to control whether to allow creating the vlan dynamically. Use the no
form of this command to restore it to the default setting. .
gvrp dynamic-vlan-creation enable
no gvrp dynamic-vlan-creation enable
Creating the vlan dynamically is not allowed.
To Next Page
Loading...
Need help?
General