CLI Reference 802.1X Configuration Commands
dot1x critical recovery action reintialize
Use this command to handle all the users that have passed the inaccessible authentication bypass
on the port after the RADIUS server recovers. Use the no form of this command to restore the
default setting.
dot1x critical recovery action reinitialize
no dot1x critical recovery action reinitialize
By default, no operation will be performed after the server recovers.
Interface configuration mode
After the inaccessible authentication bypass function is enabled on the interface
due to the server failure, when the RADIUS server recovers, the identities of all the
users who have been authorized through the inaccessible authentication bypass
function to access the network must be re-authenticated.
Ruijie# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Ruijie(config)# interface fa 0/10
Ruijie(config-if)# dot1x port-control auto
Ruijie(config-if)# dot1x critical recovery action reinitialize
Ruijie(config-if)# end
dot1x critical vlan
Use this command to configure the port to switch to the specified failed vlan when IAB is enabled.
This function is disabled by default. Use the no form of this command to restore the default setting.
To Next Page
Loading...
Need help?
General