Ruijie RG-S2600G-I Series - Lldp Enable; Lldp Encapsulation Snap

CLI ReferenceInterface Configuration Commands LLDP Configuration Commands
lldp enable
Enable the LLDP globally or on the interface. Use no form of this command to disable LLDP globally or
on the interface.
lldp enable
no lldp enable
Parameter
description
Parameter
Description
-
-
Default
Enabled.
Command
mode
Global (or interface) configuration mode
Usage
guidelines
LLDP takes effect on an interface only when LLDP is enabled globally.
Examples
Disable LLDP globally and on the interface:
Ruijie#configure terminal
Ruijie(config)#no lldp enable
Ruijie(config)#interface gigabitethernet 0/1
Ruijie(config-if-GigabitEthernet 0/1)# no lldp enable
Related
commands
Command
Description
show lldp status
Display LLDP status information
Platform
description
Only supported by switch products.
lldp encapsulation snap
Configure the encapsulation format of LLDP packets. By default, Ethernet II encapsulation is used.
lldp encapsulation snap
no lldp encapsulation snap
Parameter
description
Parameter
Description
-
-
Default
By default, Ethernet II encapsulation format is used.