CLI ReferenceInterface Configuration Commands LLDP Configuration Commands
Only supported by switch products.
Configure device type information. Use no form of this command to delete the device type information.
Device type, Value range: 0-2
0 indicates the device type is DHCP Server.
1 indicates the device type is Switch.
2 indicates the device type is LLDP MED terminal.
LLDP Civic Address configuration mode
Enter the LLDP Civic Address configuration mode and configure the device type in the common LLDP
address information.
Configure the information of lldp Civic Address (ID: 1): device type: Switch.
Ruijie#config
Ruijie(config)# lldp location civic-location identifier 1
Ruijie(config-lldp-civic)# device-type 1
show lldp location civic-location { identifier id | interface
interface-name | static }
Show the LLDP Civic Address
information.
Only supported by switch products.
To Next Page
Loading...
Need help?
General