CLI Reference IP Address Configuration Commands
The times of sending the same ARP request in the range
1 to100..When it is set as 1, it indicates that the ARP
request is not retransmitted, only 1 ARP request
message is sent.
If the ARP response message is not received, the ARP request message will be sent
for 5 times, and then it will be timed out.
Global configuration mode.
The switch sends the ARP request message frequently, and thus causing problems
like network busy. In this case, you can set the retry times of the ARP request
smaller. In general, the retry times should not be set too large.
The following configuration will set the local ARP request not to be retried.
arp retry times 1
The following configuration will set the local ARP request to be retried for one time.
arp retry times 2
arp retry interval seconds
Set the retry interval of the ARP request
message.
Use this command to configure the timeout for the ARP static mapping record in the
ARP cache. The no form of this command restores it to the default configuration.
The timeout ranging 0 to 2147483 seconds
To Next Page
Loading...
Need help?
General