CLI Reference IP Address Configuration Commands
Use this command to set the frequency for sending the arp request message
locally, namely, the time interval between two continuous ARP requests sent for
resolving one IP address. The no form of this command is used to restore the
default value, that is, retry an ARP request per second.
arp retry interval seconds
Time for retrying the ARP request message in the
range of 1 to 3600 seconds, 1 second by default
The retry interval of the ARP request is 1s.
Global configuration mode.
The switch sends the ARP request message frequently, and thus causing
problems like network busy. In this case, you can set the retry interval of the ARP
request message longer. In general, it should not exceed the aging time of the
dynamic ARP entry.
The following configuration sets the retry interval of the ARP request as 30s.
arp retry interval 30
Set the retry time of the ARP request
message.
Use this command to set the local retry times of the ARP request message, namely,
the times of sending the ARP request message to resolve one IP address. The no
form of this command can be used to restore the default 5 times of the ARP retry
requests.
To Next Page
Loading...
Need help?
General