CLI Reference DHCPv6 Snooping Configuration Commands
View the configuration information of
the DHCPv6 snooping.
This command is supported on all switches.
ipv6 dhcp snooping trust
Use this command to set the specified DHCPv6 Snooping ports as the trusted ports. The no form of this
command sets the ports as untrust ports.
ipv6 dhcp snooping trust
no ipv6 dhcp snooping trust
All ports are untrust ports.
Interface configuration mode.
Use this command to set the port as trust port. The DHCPv6 Server
response messages received under the trust port are forwarded
normally, but the response messages received under the untrust port
will be discarded.
The following is an example of setting fastEthernet 0/1 as a trust
port:
Ruijie(config)# interface fastEthernet 0/1
Ruijie(config-if)# ipv6 dhcp snooping trust
View the configuration information of the
DHCPv6 snooping.
This command is supported on all switches.