CLI Reference Guide Cluster Management Configuration Commands
The following example shows the candidate devices on the
commander devices.
Ruijie# show cluster candidates
MAC Hops LcPort UpSN UpMAC UpPort
--------------- ---- ------ ---- --------------- -------
00d0.f8fe.43d2 1 Fa0/2 0 00d0.f8fe.1007 Fa0/3
00d0.f8fe.a861 2 Fa0/5 - 00d0.f8fe.43d2 Fa0/12
MAC address of the candidate
device.
Topology hops between the
candidate devices and clusters.
Port connecting with the uplink
device on the candidate devices.
Cluster member number of the
uplink device( if it is the cluster
member)
MAC address of the uplink device.
Port connection with the candidate
device on the uplink device.
Add a member device into the
cluster.
Enable the cluster function on the
device.
This command is only supported on the switches.
show cluster member
Use this command to show the member devices.
show cluster members [number | detail]
To Next Page
Loading...
Need help?
General