CLI Reference DHCPv6 Configuration Commands
DHCPv6 Configuration Commands
clear ipv6 dhcp client
Use this command to reset the DHCPv6 client.
clear ipv6 dhcp client interface-type interface-number
interface-type
interface-number
Set the interface type and the interface number.
This command is used to reset the DHCPv6 client, which may lead the client to request for the
configurations from the server again.
Ruijie# clear ipv6 dhcp client vlan 1
If an IPv6 address conflict is detected, the DHCPv6 client will send the Decline message. Then the
DHCPv6 server will add the address in this message into the address conflict queue. The addresses
added into the address conflict queue cannot be assigned any longer. Use this command to clear the
address conflicts.
clear ipv6 dhcp conflict { ipv6-address | * }
To Next Page
Loading...
Need help?
General